/i.s3.glbimg.com/v1/AUTH_63b422c2caee4269b8b34177e8876b93/internal_photos/bs/2023/t/T/6SmwvXQm6AmTRUTwtKGQ/mounjaro-pens-desktop.png)
★★★★★ 5
Ya Just Gotta Have One
Size: 7.2 Surround + 3 HDMI
This is a must-have for in-wall wiring of your surround. I chose this one because I installed a 7.2 system with gold-plated jacks and it worked out great. You can get almost any combination of HDMI, subs/surrounds that you need (5.1, 5.2, 7.1, 7.2 etc). Do your planning on location and wire-routing; get good quality speaker wire and HDMI (high-speed with Audio Return Channel); get the remod-style mounting bracket/box then cut your hole at the same height/level as your electrical outlets and preferably between the same studs as your TV's wire-box so your HDMIs just run straight up to the TV (remember to install the bracket BEFORE you run your wires). When connecting the wires to these terminals, it's best to have 10 to 12 inches of wire coming out of the wall because you need space for your hands to manipulate the wires and nuts on the terminals. If you have a basement with access to the floor below the mounting location, it's best to drill 4 half-inch holes straight up through the bottom plate of the wall and feed your wires up those holes. Tip: If your TV and Surround Receiver are fully compatible you really only need 1 HDMI port on the wall plate, because you can plug your devices into the receiver and just sent the A/V/data to the TV while the audio is returned over the same HDMI.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 2, 2016
